Selection method of concrete mixing plant base
November 11, 2021
Many details need to be considered when installing the concrete mixing plant. For example, the selection of foundation is the main focus before the construction of the plant. Today, YCZG gives you a detailed introduction.
- First, the foundation level of the mixing plant must be checked with a level gauge and hyperplane. Preparation of pre laid iron as per drawing BSU. The size of embedded hardware should not be changed at will. In case of any change, please inform the technicians, and provide written proof to require the laying of steel mesh on the foundation of the mixing plant. Reinforcement anchor bolts shall not be less than the dimensions required by the drawings. The excavation depth and width required for the foundation shall not be less than the dimensions required by the drawings. The drawings shall not be resized and marked at will. In case of any change, the local technical management department shall be notified to obtain a written certificate.
- According to the specifications of the concrete mixing plant, set out the line and find the datum point. The error size between the two bases shall not exceed 50mm. The size of lime poured from the center of the base and the scope of excavation size. After mining the foundation with qualified pouring concrete, the secondary pouring must be carried out. During foundation excavation, the position of foundation center line shall be reserved with steel beam or gravel, and the requirements shall be clearly marked. The two built-in centerlines of iron parts on the same foundation must be aligned with a deviation of no more than 20mm. The pre stacked iron before placement shall be above the ground level and adjacent to the buried iron level, parallel and free of distortion and eccentricity.
TAG:  concrete plants concrete batching plants concrete plants cost